Whirlpool Repair

Despite its reputation for producing the most reliable washing machines, Whirlpool’s washers can and do break. When your washing machine needs Whirlpool repair, we are here for you. The most common part of a Whirlpool washer to break down is the Coupler 285753. It is a vital part that connects the motor and transmission. If this breaks, the washer will not be able to cycle or spin, leaving the washer unfunctional.

Other parts in a Whirlpool that over time might wear down and need repair are the agitator dogs, lid switch, pump, and spin basket drives.

Lid switches are designed to shut off the power to the motor if the lid is raised during the spin cycle. The newest models of washing machines have lid switches that shut off power to the washer in both the wash and spin cycle. The lid switch is made of a plastic housing with two screws holding it to the cabinet. Since the lid is opened and closed during regular use, the lid switch may separate or break apart from the mounting screws. This causes the contact parts inside the switch to not work properly.

Your washer’s pump will need Whirlpool repair if the seal starts leaking. If water is forming on the floor opposite the middle of the front panel, it's a good chance you’re having problems with the pump. Tip back the machine toward the wall and have a look at the washer’s pump from underneath. The pump is attached to the front of the motor with clips. If water is leaking, it’s best to fix it right away since water from the pump rusts the motor shaft and can cause the pump to be stuck to the motor, eventually ruining your machine.

Agitator dogs are a common problem with the two piece agitators. If the upper half of the agitator is not ratcheting back and forth with the lower half, your washer’s dogs need to be changed. While the power is off, turn the top half of the agitator in both directions. If the agitator turns both ways then you need a doggie kit.

The spin basket drive is probably the most difficult part to diagnose and to do a Whirlpool. The basket drive keeps the inner tub from spinning during the wash cycle and engages the inner tub during the spin cycle. If your clothes are dripping wet at the end of the spin cycle, the basket drive might be the culprit. To check the cause, fill the washer with water and see if it agitates.

After seeing the washer agitate, set the timer for the spin cycle. All the water will drain, and the inner tub should spin. Open the lid and activate the lid switch to observe the action of the tub. If the inner tub does not spin, try to start the spinning by pushing the tub with your hand. If the tub does not spin, then the a problem is coming from the basket drive.